IBM 81Y Manual Do Utilizador
184
Hardware Maintenance Manual: xSeries 250
•
Chinese
•
French
•
German
•
Italian
•
Korean
•
Spanish
Important:
All caution and danger statements in this IBM documentation begin with
a number. This number is used to cross reference an English caution or
danger statement with translated versions of the caution or danger
statement in this section.
a number. This number is used to cross reference an English caution or
danger statement with translated versions of the caution or danger
statement in this section.
For example, if a caution statement begins with a number 1, translations
for that caution statement appear in this section under statement 1.
for that caution statement appear in this section under statement 1.
Be sure to read all caution and danger statements before performing any
of the instructions.
of the instructions.
•
Statement 1
DANGER
Electrical current from power, telephone and communication cables is hazardous.
To avoid a shock hazard:
•
Do not connect or disconnect any cables or perform installation, maintenance,
or reconfiguration of this product during an electrical storm.
or reconfiguration of this product during an electrical storm.
•
Connect all power cords to a properly wired and grounded electrical outlet.
•
Connect to properly wired outlets any equipment that will be attached to this
product.
product.
•
When possible, use one hand only to connect or disconnect signal cables.
•
Never turn on any equipment when there is evidence of fire, water, or
structural damage.
structural damage.
•
Disconnect the attached power cords, telecommunications systems, networks,
and modems before you open the device covers, unless instructed otherwise in
the installation and configuration procedure
and modems before you open the device covers, unless instructed otherwise in
the installation and configuration procedure
s.
•
Connect and disconnect cables as described in the following table when
installing, moving, or opening covers on this product or attached devices.
installing, moving, or opening covers on this product or attached devices.
•
Statement 2
To Connect
To Disconnect
1.
Turn everything OFF.
2.
First, attach all cables to devices.
3.
Attach signal cables to connectors.
4.
Attach power cords to outlet.
5.
Turn device ON.
1.
Turn everything OFF.
2.
First, remove power cords from outlet.
3.
Remove signal cables from connectors.
4.
Remove all cables from devices.