Seagate ST1000NM0011 Manual Do Utilizador
C
ONSTELLATION
ES S
ERIAL
ATA P
RODUCT
M
ANUAL
, R
EV
. F
13
500GB model current profile
Figure 3.
Typical 500GB model 5V & 12V startup and operation current profiles
2.8.2
Conducted noise
Input noise ripple is measured at the host system power supply across an equivalent 80-ohm resistive load on the +12 V line or an
equivalent 15-ohm resistive load on the +5V line.
• Using 12V power, the drive is expected to operate with a maximum of 120mV peak-to-peak square-wave injected noise at up to 10MHz.
• Using 5V power, the drive is expected to operate with a maximum of
equivalent 15-ohm resistive load on the +5V line.
• Using 12V power, the drive is expected to operate with a maximum of 120mV peak-to-peak square-wave injected noise at up to 10MHz.
• Using 5V power, the drive is expected to operate with a maximum of
100mV peak-to-peak square-wave injected noise at up to 10MHz.
Note.
Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current.
2.8.3
Voltage tolerance
Voltage tolerance (including noise):
5V ± 5%
12V ±10%
12V ±10%