Samsung 3.5" hard disk drives Manual Do Utilizador

INSTALLATION 
 

SpinPoint V40 Product Manual

 

18

 

 

This mode is selected as the factory default. It configures the 
drive as the Master. 

 

 

Select this mode to configure the drive as the Slave.

 

 

 

Select this mode if the Cable Select feature of the AT Bus 
Interface is to be used for Master / Slave selection.

 

 

 

Select this mode to limit the capacity of the drive to 32 gigabytes 
and configure the drive as the Master, or to help install the drive 
to access the full capacity of the drive as the Master in certain old 
PC systems. 

 

Select this mode to limit the capacity of the drive to 32 gigabytes 
and configure the drive as the Slave, or to help install the drive to 
access the full capacity of the drive as the Slave in certain old PC 
systems.

 

 

Select this mode to limit the capacity of the drive to 32 GB and 
use the Cable Select feature of the AT Bus Interface for Master / 
Slave selection, or to help install the drive to access the full 
capacity of the drive using Cable Select feature in certain old PC 
systems.

 

 

NOTES: 

•

  The 32GB Clip may be required for the hard disk drive to be recognized by systems that incorporate 

specific older BIOS. For the installation instructions, refer to section “4.7.1 Drive Installation to Access 
the Full Capacity Using 32GB Clip.” 

•

  The ATA standard allows for daisy-chaining up to two drives on the AT-Bus interface. When daisy-

chaining two drives, specify one drive as the Master and the other as the Slave. Both drives could also be 
set to Cable Select Mode if the host is using the Cable Select feature of the AT Bus Interface. 

 

•

  SpinPoint V40 hard disk drives are shipped from the factory in Master Mode (Drive 0).