Lucent Technologies R5SI Manual Do Utilizador

Issue 1

April 1997

Maintenance Object Repair Procedures 

Page 10-1039

PE-BCHL (PRI Endpoint Port) 

This test sends port level translation data from the switch processor to the UDS1 
interface circuit pack to ensure that the port’s translation is correct. The port audit 
operation verifies the consistency of the current state of the port that is kept in the 
UDS1 interface circuit pack and in the switch software.

2000

ABORT

Response to the test request was not received within the allowable time 
period.

2100

ABORT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals a maximum of 5 times.

Any

FAIL

The NPE of the tested port did not conference the tones correctly. This 
causes noisy and unreliable connections.

1. Replace the circuit pack. Even though wideband calls do not use the 

conferencing feature on the NPE, this failure indicates problems with 
the circuit pack hardware.

PASS

The port can correctly conference multiple connections. User-reported 
troubles on this port should be investigated by using the other port tests 
and by examining the terminal adapter or the external wiring.

ABORT

Internal system error

2000

ABORT

Response to the test request was not received within the allowable time 
period.

2100

ABORT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals a maximum of 5 times.

FAIL

The test failed due to Internal system error.

1. Retry the command at 1-minute intervals a maximum of 5 times.