Lucent Technologies R5SI Manual Do Utilizador
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1474
TIE-TRK (Tie Trunk)
10
Transmission Test (#844-848)
This test is non-destructive.
NOTE:
Tests #844-848 are not supported on a International switch.
Tests #844-848 are not supported on a International switch.
These tests are run by the Automatic Transmission Measurement System
(ATMS). They are not part of the long or short trunk test sequences. Instead, they
are run on demand with the
(ATMS). They are not part of the long or short trunk test sequences. Instead, they
are run on demand with the
test analog-testcall
command or as part of ATMS
scheduled testing.
The test call is run from an analog port on a TN771 Maintenance/Test circuit
pack. It attempts to seize a port and make a call to a terminating test line (TTL) on
the trunk’s far end. Transmission performance measurements are made and
compared to administered thresholds. Errors are generated when results fall
outside of ‘‘marginal’’ or ‘‘unacceptable’’ thresholds. Detail and summary
measurement reports are obtainable via the
pack. It attempts to seize a port and make a call to a terminating test line (TTL) on
the trunk’s far end. Transmission performance measurements are made and
compared to administered thresholds. Errors are generated when results fall
outside of ‘‘marginal’’ or ‘‘unacceptable’’ thresholds. Detail and summary
measurement reports are obtainable via the
list testcalls
command.
Table 10-447.
TEST #844-848 Transmission Test
Error
Code
Test
Result
Description/ Recommendation
1000
ABORT
System resources required to run this test are not
available. The port may be busy with a valid call. Use
available. The port may be busy with a valid call. Use
display port PCSSpp
to determine the trunk
group/member number of the port. Use the "status trunk"
command to determine the service state of the port. If
the service state indicates that the port is in use, then
the port unavailable for this test. (Refer to the "Status
Commands" section in
command to determine the service state of the port. If
the service state indicates that the port is in use, then
the port unavailable for this test. (Refer to the "Status
Commands" section in
for a full
description of all possible states.) You must wait until the
port is idle before retesting.
port is idle before retesting.
1. If the port status is idle, then retry the command at 1
minute intervals for a maximum of 5 retries.
2. If the test continues to abort escalate the problem.
1001
ABORT
Could not allocate the necessary system resources to
run this test.
run this test.
1. Retry the command at 1 minute intervals for a
maximum of 5 retries.
2. If the test continues to abort escalate the problem.
Continued on next page