Lucent Technologies R5SI Manual Do Utilizador

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-73

clear audits 

This command is used to clear the cumulative and/or peak hour’s data that has 
been collected for each data relation audit. The purpose of this command is to 
clear old data so that when the "status audits" command is used only data 
collected since the last "clear audits" command is displayed. With this command, 
the user can clear the peak hour’s data that has been collected or both the peak 
hour and cumulative data (refer to the "status audits" manual page for more 
information).

None

If the technician presses 

HELP

 after entering "clear audits" the following message 

will be displayed:

 peak-hour    cumulative

If during the execution of a command a resource problem occurs that requires 
the user to restart the command, then the following message will be displayed:

 Command resources busy; Press CANCEL to clear, and then resubmit

If all of the available maintenance resources are currently in use, then the 
following message will be displayed:

 All maintenance resources busy; try again later

If the clear audits command is successful, the following message will be 
displayed on the SAT:

 Command successfully completed

If the clear audits command is unsuccessful, the following message will be 
displayed on the SAT:

cumulative

This option will cause the data collected since the last reboot or "clear 
audits cumulative" command and the data collected about the peak 
hour to be cleared.

peak-hour

This option will cause the data collected about the peak hour to be 
cleared.