Lucent Technologies R5SI Manual Do Utilizador

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-656

test signaling-group 

If the specified group identifier is not administered, the following message is 
displayed:

No signaling group assigned

If no tests can be found for the associated MO, the following message is 
displayed:

No tests for this MO

If the software data cannot be sent to the SAT, the following message is 
displayed:

Error encountered, can’t complete request

If during the execution of a command a resource problem occurs that requires 
the user to restart the command, then the following message is displayed:

Command resources busy;

Press CANCEL to clear, and then resubmit

If all of the available maintenance resources are currently in use, then the 
following message is displayed:

All maintenance resources busy; try again later

The responses will be displayed on a test-by-test basis with one line of data 
displayed for each test result.

For the following output example, assume that the command "test 
signaling-group 1" was entered.

Port

The signaling group number (1-8) of the signaling group that is 
being tested.

Maintenance Name

The type of maintenance object that is being tested.

Alt. Name

Not Applicable.

Test No

The actual test that is being executed.

Result

The result of the individual test -"PASS," "ABORT," "FAIL," "NO 
BOARD," "DISABLED," "EXTRA BD."

Error Code

A system-generated number that tells why the test failed or 
aborted. A detailed list of the codes according to "Test No." is 
provided for each MO [for example, see MO section on 
"ISDN-SGR (ISDN-PRI Signaling Group)"].