Lucent Technologies R5SI Manual Do Utilizador

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-686

upgrade software 

None.

If the system technician presses 

HELP

 after entering "upgrade software," the 

following message is displayed:

Entry is not required

If no card-mem is loaded into the system, the following message will be 
displayed:

Software card-mem is not inserted in the system

If a wrong card-mem is loaded into the system, the following message will be 
displayed:

Incorrect card-mem loaded; insert software card-mem

If the directory information on the software card-mem is corrupted or the 
card-mem is not formatted properly, the following message will be displayed:

Software card-mem not readable; try another card-mem

If this command is in conflict with another currently executing command, then a 
message will be displayed showing the login id of the conflicting user and the 
conflicting command. The message is as follows:

’login id’:’command’ has a command conflict

If the checksum on the software card-mem is bad, the following message will be 
displayed:

Bad checksum on software card-mem; try another card-mem

If the software upgrade failed in the standby SPE, the following message will be 
displayed:

No response on upgrade status from standby SPE, command failed

If the software card-mem in the standby SPE is not replaced with a translation 
card-mem within 2 minutes, the following message will be displayed:

No translation card-mem inserted 

in the standby SPE, command aborted

If the flash text checksum failed after the standby upgrade, the following 
message will be displayed:

Standby SPE text checksum failed, command aborted

If the software card-mem is not inserted in the active SPE within 2 minutes after 
the prompting string: "REPLACE TRANSLATION CARD-MEM ON <active 
carrier> WITH SOFTWARE CARD-MEM," the command has to be retried again 
and the following message will be displayed:

No software card-mem inserted in active SPE; command aborted