Renesas 32176 Manual Do Utilizador

32176 Group 

Starter Kit User’s Manual M3A-2152 

REJ10B0224-0300/Rev.3.00 

Jan. 2007 

Page 15 of 82 

 

5.2.3  M3A-2152 Evaluation Board Power Supply and Settings 

The following shows how to set the M3A-2152 Evaluation Board.   
Use a 5V DC power supply to feed power to the M3A-2152 Evaluation Board.     
Use included 5V power supply cable to connect the 5V DC power supply and CN2 connector 
included with the M3A-2152 Evaluation Board. The Connecting when Feeding Power to the 
M3A-2152 Evaluation Board is shown in Figure 5.6. 

 

 

 

 
 

 

 
 

 

 
 
Figure 5.6    Connecting when Feeding Power to the M3A-2152 Evaluation Board 
 
Table 5.4    Jumper Settings before Shipmen 

Jumper Name 

Jumper Settings 

Remarks 

H1 

Shorted between 1-2 

Uses power from CN2 connector to AVCC power supply 

Note: For detail about the power supply settings, refer to Appendix 3 M3A-2152G02 Product Standards 

 

5.2.4  Connecting M3A-2152 Evaluation Board and M3A-2195 

Use included 10-pin Flat cable to connect M3A-2195 and XCN1 connector included with the 
M3A-2152 Evaluation Board.   
The Connecting M3A-2152 Evaluation Board and M3 is shown in Figure 5.7. 

 

 

 

 

 
 

 

 
 

 

 
 
Figure 5.7    Connecting M3A-2152 Evaluation Board and M3A-2195 
 

5.2.5  System Power-on Sequence when M3A-2152G52 in Use 

- 

When turning on power, turn on M3A-2195 first and then the M3A-2152 Evaluation Board, or 
simultaneously. 

- 

When turning off power, turn off the M3A-2152 Evaluation Board first and then M3A-2195, or 
simultaneously. 

- 

 When turning on power again after turning off power, wait for 2 seconds. 

 

 

 

Note: Unless the Starter Kit is powered on this sequence, the kit may operate erratically or break down. 

 

M3A-2152 evaluation board

XCN1

10-pin flat cable

M3A-2195

JTAG

4.75 - 5.25V DC  power supply

M3A-2152 evaluation board

CN2

H1