Polycom 3725-23487-003/A Manual Do Utilizador

User’s Guide for the Polycom Mobile Responder

3 - 2

The system does not 
start or respond in 
any way.

The Power button is off.

Press the Power button located inside the side panel 
to the on position.

Wait one to two minutes for the system to 
completely power on. 

The power cable is not 
connected.

Make sure the power cable is connected to a power 
outlet, and that the power cable is seated securely both 
in the outlet and in the Mobile Responder.

The power outlet is not active, 
or the system’s power cable 
is not operating properly.

Check the power outlet by unplugging the system and 
plugging in a lamp, radio, or other small appliance. If it 
does not operate, the outlet is not active — connect the 
system to a different outlet. 
If the outlet is active, the problem may be in the Mobile 
Responder’s power cable. In this case, call Polycom 
Technical Support. 

The power interlock switch is 
pushed down.

Make sure that the power interlock switch, which turns off 
power to the lid, is up (refer to 

 

on page 

 for an illustration showing where the power 

interlock switch is located).

The screen is blank.

The system is in standby 
mode.

Pick up the remote control to activate the system.

The power for the display is 
off.

Press the LCD Power button to turn the display on (refer 
to 

 on page 

 for an illustration 

showing where the LCD Power button is located).

The wrong display mode is 
selected.

Press the LCD Up/Display Mode button until you set the 
display mode to RGB (refer to 

on page 

 for an illustration showing where the LCD 

Up/Display Mode button is located).