Dialogic M7324 Manual Do Utilizador

Nortel MICS switches typically support connections for up to 16 voice mail 
ports. If more than 16 voice mail ports are connected simultaneously, the 
resulting traffic may overload the switch, resulting in symptoms such as very 
slow switch response, lost LED updates, incomplete display updates, and lost 
calls. 

If using Dialogic

®

 D/42JCT-U or D/82JCT-U PBX Integration Boards with 

the Nortel MICS switch, “Nortel_Norstar.fwl” should be selected. (On 
Windows

®

 systems, this is selected in the Dialogic

®

 Configuration Manager 

(DCM). On Linux systems, this is selected in the configuration file 
/usr/dialogic/cfg/dialogic.cfg.) This firmware boots the board ports into voice 
mail mode. Therefore, it can be beneficial for the programming of any MICS 
system to be carefully reviewed to verify that no more than 16 ports are 
connected in voice mail mode. 

It is possible to use Dialogic

® 

D/42JCT-U or D/82JCT-U Boards with 

the Nortel MICS switch without the connected ports operating in 
voice mail mode. If doing so, load “Nortel_BCM.FWL” in DCM (on 
Windows systems) or in the configuration file 
/usr/dialogic/cfg/dialogic.cfg (on Linux systems). This firmware does 
not boot the ports in voice mail mode. Keep in mind that in this 
configuration, these ports have blank CPID information and they are 
not able to set or clear Message Waiting indicators. 

All programming is done by a phone or other KSU tool and the programmer 
should be logged in as config. These programming settings are required for 
proper functionality of the Dialogic

® 

PBX Integration Boards.  

Terminals and Sets (for each Dialogic

® 

D/82 or D/42 port) 

Line Access: 

Line Assignment: 

Line00N: Ring only – for all trunk lines being used  

(First D/82 or D/42 port only. Unassigned for all other 
ports.) 

Line Pool Access: 

Pool A: Y 
Pool B: N 
Pool C: N