ASUS M2N-L Manual Do Utilizador

ASUS M2N-L

2-

This connector is for the provided floppy disk drive (FDD) signal cable. Insert 

one end of the cable to this connector, then connect the other end to the 

signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection when 

using a FDD cable with a covered Pin 5.

The onboard IDE connector is for the Ultra DMA 133/100/66/33 signal cable. 

There are three connectors on each Ultra DMA 133/100/66/33 signal cable: 

blue, black, and gray. Connect the blue connector to the motherboard’s IDE 

connector, then select one of the following modes to configure your device.

NOTE: Orient the red markings on

the floppy ribbon cable to PIN 1.

PIN1

FLOPPY

®

®

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PRI_IDE

PI

N 

1