AMCC 9590SE-4ME Manual Do Utilizador
Controller Object Commands
www.3ware.com
27
Typical output looks like:
//localhost> /c0 show
Unit UnitType Status %Cmpl Stripe Size(GB) Cache AVerify IgnECC
--------------------------------------------------------------------------
u0 RAID-1 OK - - 149.05 ON OFF OFF
u1 RAID-5 OK - 64k 298.22 ON OFF OFF
u2 SPARE OK - - 149.05 ON OFF -
Port Status Unit Size Blocks Serial
---------------------------------------------------------------
p0 OK u0 149.05 GB 312581808 3JS0TF14
p1 OK u0 149.05 GB 312581808 3JS0TETZ
p2 OK u1 149.05 GB 312581808 3JS0VG85
p3 OK u1 149.05 GB 312581808 3JS0VGCY
p4 OK u1 149.05 GB 312581808 3JS0VGGQ
p5 OK u2 149.05 GB 312581808 3JS0VH1P
p6 OK - 149.05 GB 312581808 3JS0TF0P
p7 OK - 149.05 GB 312581808 3JS0VF43
p8 OK - 149.05 GB 312581808 3JS0VG8D
p9 NOT-PRESENT - - - -
p10 NOT-PRESENT - - - -
p11 NOT-PRESENT - - - -
Name OnlineState BBUReady Status Volt Temp Hours LastCapTest
---------------------------------------------------------------------------
bbu On Yes OK OK OK 241 22-Jun-2004
/c
x
show
attribute
[
attribute
...]
This command shows the current setting of the specified attributes on the
specified controller. One or many attributes can be specified. Specifying an
invalid attribute will terminate the loop. Possible attributes are: achip,
allunitstatus, autocarve (9000 series), autorebuild (9550SX and 9590SE only),
bios, carvesize (9000 series), driver, drivestatus, exportjbod (9000 series),
firmware, memory, model, monitor, numdrives, numports, numunits, ctlbus
(9550SX and 9590SE only), ondegrade (9500S), pcb, pchip, qpolicy, serial,
spinup (9000 series), stagger (9000 series), and unitstatus.
specified controller. One or many attributes can be specified. Specifying an
invalid attribute will terminate the loop. Possible attributes are: achip,
allunitstatus, autocarve (9000 series), autorebuild (9550SX and 9590SE only),
bios, carvesize (9000 series), driver, drivestatus, exportjbod (9000 series),
firmware, memory, model, monitor, numdrives, numports, numunits, ctlbus
(9550SX and 9590SE only), ondegrade (9500S), pcb, pchip, qpolicy, serial,
spinup (9000 series), stagger (9000 series), and unitstatus.
Example:
To see the driver and firmware installed on controller 0, enter the
following:
//localhost> /c0 show driver firmware
/c0 Driver Version = 2.x
/c0 Firmware Version = FE9X 2.x
Where x=actual version