AMCC 9590SE-4ME Manual Do Utilizador

Unit Object Commands

53

Unit Object Commands

Unit Object commands provide information and perform actions related to a 
specific unit, such as 

/c0/u1 

(unit 1 on controller 0). For example, you use 

logical disk object commands for such tasks as seeing the rebuild, verify, or 
initialize status of a unit, starting, stopping, and resuming rebuilds and 
verifies, and setting policies for the unit. 

/cx/ux show                                            

/cx/ux show attribute [attribute ...] where attributes are:

initializestatus|name(9000 series)|

qpolicy(9550SX and 9590SE only)|rebuildstatus|

serial(9000 series)|status|verifystatus|

storsave(9550SX and 9590SE only)|volumes(9000 series)|

identify (9550SX and 9590SE only)

/cx/ux show all                                           

/cx/ux start rebuild disk=<p:-p...> [ignoreECC] 

/cx/ux start verify

/cx/ux pause rebuild               (7000/8000 only)

/cx/ux resume rebuild              (7000/8000 only)

/cx/ux stop verify

/cx/ux flush

/cx/ux del [noscan] [quiet]

/cx/ux set autoverify=on|off

/cx/ux set cache=on|off [quiet]

/cx/ux set identify=on|off         (9550SX and 9590SE only)

/cx/ux set ignoreECC=on|off

/cx/ux set qpolicy=on|off          (9550SX and 9590SE only)

/cx/ux set name=string             (9000 series)

/cx/ux set storsave=protect|balance|perform [quiet](9550SX 

and 9590SE only)

/cx/ux migrate type=RaidType [disk=p:-p] [group=3|4|5|6]

[stripe=Stripe] [noscan] [nocache] [autoverify] 

(9000 only)

/cx/ux remove [noscan] [quiet]

/c

x

/u

x

 show

This command shows summary information about the specified unit /cx/ux. If 
the unit consists of sub-units as with the case of RAID-1, RAID-5, RAID-10, 
RAID-50, then each sub-unit is further presented. If the Auto-Carving policy 
was on at the time the unit was created and the unit is over the carve size, 
multiple volumes were created and are displayed at the end of the summary 
information.