Primera Technology 510212 Manual Do Utilizador

4. Once all appropriate printer settings have been chosen, select OK to close the

setup window.  Select OK from the Printing window to send your print job to

the press.

Before printing actually starts, the print job must be processed or rasterized.  This

will take anywhere from several seconds to several minutes depending on the

complexity of your image and the speed of your computer.  Your computer will not

be able to perform any other task while it is processing your job.   Once the print

job finished rasterizing, your computer will release the job, and you will hear the

press begin to feed the first sheet of print media. 
Your press will simultaneously print and cut as many sheets of output as you

originally specified.  While printing, you may wish to bring the 32-Bit Spooler to

the foreground in order to monitor the status of the print job.  If you experience an

error during printing, you can use the 32-Bit Print Spooler to pause the print job

while you clear any recoverable errors such as an initial print media or ribbon jam.

Once the error is cleared, select Resume in the spooler to resume printing.  After a

minute or two, the press will once again begin printing your print job.  
If you need to adjust the cut pressure during the print job, use the Cutting Pressure

slide on Control Panel.  See Section 3-D for information on when and how to adjust

the Cutting Pressure slide.  For more information on dealing with possible print

errors, please refer to Section 9.  For important hints on efficiently working with

the PressPrint software, please refer to Part F of this section.

53

Impressa3.qxd  10/22/01  9:29 PM  Page 53