Multi-Tech Systems MVP 800 Manual Do Utilizador
36
Chapter 3 - Software Loading and Configuration
If you are connecting the station side of a telephone switch (PBX) to your MultiVOIP, connect one
end of an RJ11 phone cord to the Voice/Fax Channel 1 FXO connector on the back of the
MultiVOIP and the other end to the phone jack.
end of an RJ11 phone cord to the Voice/Fax Channel 1 FXO connector on the back of the
MultiVOIP and the other end to the phone jack.
If you are connecting an E&M trunk from a telephone switch to your MultiVOIP, connect one end
of an RJ45 phone cord to the Voice/Fax Channel 1 E&M connector on the back of the MultiVOIP
and the other end to the trunk. Refer to Appendix B for E&M cabling pinout.
of an RJ45 phone cord to the Voice/Fax Channel 1 E&M connector on the back of the MultiVOIP
and the other end to the trunk. Refer to Appendix B for E&M cabling pinout.
7.
Repeat the above step to connect the remaining telephone equipment to each Voice/Fax
Channel on your MultiVOIP.
Channel on your MultiVOIP.
8.
Turn on power to the MultiVOIP by placing the ON/OFF switch on the back panel to the ON
position. Wait for the BOOT LED on the MultiVOIP to go off before proceeding. This may take a
couple of minutes to go off.
position. Wait for the BOOT LED on the MultiVOIP to go off before proceeding. This may take a
couple of minutes to go off.
9.
At this time your VOIP network should be fully operational. Dial one of the sites in your network
using the dialing directory supplied by your VOIP Administrator.
using the dialing directory supplied by your VOIP Administrator.