Philips 253117544-B Manual Do Utilizador
General Safety Information ·
5
EN
1 General Safety Information
Introduction 3
Your device has been tested in conformity with standards
EN 60950-1 and IEC 60950-1 and should only be oper-
ated with telephone systems and power equipment that
meet these standards. The device was built exclusively for
use in the indicated sales region.
EN 60950-1 and IEC 60950-1 and should only be oper-
ated with telephone systems and power equipment that
meet these standards. The device was built exclusively for
use in the indicated sales region.
Introduction 2
Do not make any changes or settings that are not described
in this user manual. Physical injury or damage to the
device or loss of data can result from improper handling.
Take note of all warning and safety notes indicated.
in this user manual. Physical injury or damage to the
device or loss of data can result from improper handling.
Take note of all warning and safety notes indicated.
Setting Up the Device
The device should rest securely on a stabile, flat surface.
The device should rest securely on a stabile, flat surface. If
the device should fall, it can be damaged or can cause
injury to people, especially small children. Position all
cables in such a way that no one will stumble on them, thus
avoiding possible injuries to persons or damage to the
device itself.
the device should fall, it can be damaged or can cause
injury to people, especially small children. Position all
cables in such a way that no one will stumble on them, thus
avoiding possible injuries to persons or damage to the
device itself.
The distance between the device and other appliances or objects, must be at least 15 centimetres.
The distance between the device and other devices or
objects must be at least 15 centimetres; this also applies to
the use of additional cordless telephones. Do not place the
device in the vicinity of radios or televisions.
objects must be at least 15 centimetres; this also applies to
the use of additional cordless telephones. Do not place the
device in the vicinity of radios or televisions.
Protect the device against direct sunlight
Protect the device against direct sunlight, heat, large tem-
perature fluctuations and moisture. Do not place the
device in the vicinity of heaters or air conditioners.
Observe the information on temperature and humidity in
the technical data.
perature fluctuations and moisture. Do not place the
device in the vicinity of heaters or air conditioners.
Observe the information on temperature and humidity in
the technical data.
The device must have sufficient ventilation
The device must have sufficient ventilation and may not be
covered. Do not put your device in closed cabinets or
boxes. Do not place the machine on soft surfaces such as
tablecloths or carpets and do not cover the ventilation slits.
Otherwise, the device can overheat and catch on fire.
covered. Do not put your device in closed cabinets or
boxes. Do not place the machine on soft surfaces such as
tablecloths or carpets and do not cover the ventilation slits.
Otherwise, the device can overheat and catch on fire.
The area in which you operate the device must be adequately ventilated
The area in which you operate the device must be ade-
quately ventilated, especially if the device is used fre-
quently. Set up your device in such a way that the flow of
the exhaust air stream points away from the work station.
quately ventilated, especially if the device is used fre-
quently. Set up your device in such a way that the flow of
the exhaust air stream points away from the work station.
In the event that the device becomes too hot, or if you see smoke coming from the device
In the event that the device becomes too hot, or if you see
smoke coming from the device, you must immediately pull
the power cable out of the power socket. Have your device
examined by trained professionals at a technical service
location. To prevent the spread of fire, open flames should
be kept away from the device.
smoke coming from the device, you must immediately pull
the power cable out of the power socket. Have your device
examined by trained professionals at a technical service
location. To prevent the spread of fire, open flames should
be kept away from the device.
Do not plug in the device in moist rooms.
Do not plug in the device in moist rooms. Never touch the
mains cable, the mains connection or the telephone socket
with wet hands.
mains cable, the mains connection or the telephone socket
with wet hands.
Do not allow liquids to enter into the device.
Do not allow liquids to enter into the device. Disconnect
the device from the electrical power source and from the
telephone network, if liquids or foreign objects have
entered the device and have your device examined by
trained professionals at a technical service location.
the device from the electrical power source and from the
telephone network, if liquids or foreign objects have
entered the device and have your device examined by
trained professionals at a technical service location.
Do not allow children to handle the device without supervision.
Do not allow children to handle the device without super-
vision. The packing materials should be kept out of the
hands of children.
vision. The packing materials should be kept out of the
hands of children.
Magnetic telephone handset
The telephone handset of the device is magnetic. Caution,
small metallic objects (paper clips) may be retained if
placed near or on the telephone handset.
small metallic objects (paper clips) may be retained if
placed near or on the telephone handset.
Power Supply/Telephone Line
Check whether the mains voltage of your device
Check whether the mains voltage of your device (indicated
on the type label) matches the mains voltage available at
the setup location.
on the type label) matches the mains voltage available at
the setup location.
Emissions
This device complies with EN 55022 Class B. Use only the
power and telephones cables supplied. Before you use the
device make sure that you connected the telephone cable
supplied as described.
power and telephones cables supplied. Before you use the
device make sure that you connected the telephone cable
supplied as described.
Never touch the power or telephone cable if the insulation is damaged.
Never touch the power or telephone cable if the insulation
is damaged. Replace damaged wires immediately. Use suit-
able cables only; if necessary please contact our technical
customer service or your retailer.
is damaged. Replace damaged wires immediately. Use suit-
able cables only; if necessary please contact our technical
customer service or your retailer.
Disconnect your device from the power and telephone networks during an electrical storm.
Disconnect your device from the power and telephone net-
works during an electrical storm. If this is not possible, do
not use the device during an electrical storm.
works during an electrical storm. If this is not possible, do
not use the device during an electrical storm.
Before cleaning the surface of your device, disconnect it from the power and telephone networks.
Before cleaning the surface of your device, disconnect it
from the power and telephone networks. Use a soft, lint-
free cloth. Never use liquid, gaseous or easily flammable
cleansers (sprays, abrasives, polishes, alcohol). Do not
allow any moisture to reach the interior of the device.
from the power and telephone networks. Use a soft, lint-
free cloth. Never use liquid, gaseous or easily flammable
cleansers (sprays, abrasives, polishes, alcohol). Do not
allow any moisture to reach the interior of the device.
Only clean the display with a dry, soft cloth.
Only clean the display with a dry, soft cloth. If the display
breaks, a mildly corrosive liquid may escape. Avoid all con-
tact with your skin and eyes.
breaks, a mildly corrosive liquid may escape. Avoid all con-
tact with your skin and eyes.
In the event of a power failure, your device will not function;
In the event of a power failure, your device will not func-
tion; saved data is retained.
tion; saved data is retained.
Consumable Materials
Original Consumable Material
Use only original consumable materials. These are availa-
ble from a specialised retailer or through our order service
(see back side of this user manual). Other consumable
materials could damage the device or shorten its service
life.
ble from a specialised retailer or through our order service
(see back side of this user manual). Other consumable
materials could damage the device or shorten its service
life.
Environment
Dispose of old consumable materials according to the
waste regulations of your country.
waste regulations of your country.
Caution when Handling Toner Powder:
Caution when Handling Toner Powder:
If you breathe in toner powder, go into the fresh air imme-
diately. Call a doctor immediately!
If you get toner powder in your eyes, rinse them with a lot
of water for at least 15 minutes. Call a doctor immediately!
If you have swallowed toner powder, drink small amounts
of water. Try NOT to vomit. Call a doctor immediately!
If you breathe in toner powder, go into the fresh air imme-
diately. Call a doctor immediately!
If you get toner powder in your eyes, rinse them with a lot
of water for at least 15 minutes. Call a doctor immediately!
If you have swallowed toner powder, drink small amounts
of water. Try NOT to vomit. Call a doctor immediately!
Toner Cartridge 1
Never open a toner cartridge. Store both new and used car-
tridges in a place where they will not come into the hands
of children.
tridges in a place where they will not come into the hands
of children.
Paper Jam
In case of a paper jam, remove the paper carefully out of
the device. Throw the paper away carefully: It is possible
that the toner may not be completely set on the print-out,
and toner dust could be released into the air.
the device. Throw the paper away carefully: It is possible
that the toner may not be completely set on the print-out,
and toner dust could be released into the air.
If toner dust is released into the air, you should avoid allowing it to contact your skin and eyes.
If toner dust is released into the air, you should avoid
allowing it to contact your skin and eyes. Do not inhale the
released toner dust. Remove the toner dust from clothing
or objects with cold water; hot water would only cause the
toner to set. Never remove loose toner dust with a vacuum
cleaner.
allowing it to contact your skin and eyes. Do not inhale the
released toner dust. Remove the toner dust from clothing
or objects with cold water; hot water would only cause the
toner to set. Never remove loose toner dust with a vacuum
cleaner.
lpf-5120-5125-5135-manual-uk-int-253117544-b.book Seite 5 Mittwoch, 16. Dezember 2009 10:01 10