Zebra Technologies ZT230 Manual Do Utilizador

Troubleshooting
Error Messages

P1048261-004  

8/22/12

The ZT230 control panel displays messages when there is an error. See 

 for errors, the 

possible causes, and the recommended solutions.

STATUS light steady red
PAUSE light steady yellow

The printhead is not fully 
closed.

Close the printhead 
completely.

The printhead open sensor is 
not working properly.

Call a service technician to 
replace the sensor.

STATUS light steady red
SUPPLIES light steady red

The media is not loaded or is 
loaded incorrectly.

Load media correctly.

Misaligned media sensor.

Check the position of the 
media sensor.

The printer is set for 
noncontinuous media, but 
continuous media is loaded.

Install the proper media 
type, or reset printer for the 
current media type.

Calibrate the printer. See 

.

STATUS light steady yellow
SUPPLIES light flashing yellow

Ribbon is loaded, but the 
printer is set for direct thermal 
mode.

Ribbon is not required with 
direct thermal media. If you 
are using direct thermal media, 
remove the ribbon. This error 
message will not affect 
printing.

If you are using thermal 
transfer media, which requires 
ribbon, set the printer for 
Thermal Transfer mode. See