Netgear DG834GV Manual Do Utilizador

Página de 34
Setup Manual for the DG834GV Integrated ADSL Modem and Wireless Router with Voice
Troubleshooting
2-5
v1.0, February 2006
ADSL Internet LED Off
If the ADSL Internet LED is off, disconnect all telephones on the line. If this solves the problem, 
reconnect the telephones one at a time, being careful to use a microfilter on each telephone. If the 
microfilters are connected correctly, you should be able to connect all your telephones.
If disconnecting telephones does not result in a green ADSL Internet LED the problem may be one 
of the following:
Check that the telephone company has made the connection to your line and tested it.
Verify that you are connected to the correct telephone line. If you have more than one phone 
line, be sure that you are connected to the line with the ADSL service. It may be necessary to 
use a swapper if you ADSL signal is on pins 1 and 4 of the RJ-11 jack. The ADSL Modem 
Wireless Router uses pins 2 and 3.
Obtaining an Internet IP Address
If your ADSL modem wireless router is unable to access the internet, and your Internet LED is 
green or blinking green, you should determine whether the ADSL modem wireless router is able to 
obtain a Internet IP address from the ISP. Unless you have been assigned a static IP address, your 
ADSL modem wireless router must request an IP address from the ISP. You can determine whether 
the request was successful using the browser interface.
To check the Internet IP address from the browser interface: 
1. Launch your browser and select an external site such as 
http://www.netgear.com
.
2. Access the Main Menu of the ADSL modem wireless router’s configuration at 
 
http://192.168.0.1. 
3. Under the Maintenance heading check that an IP address is shown for the Internet Port.
 
If 0.0.0.0 is shown, your ADSL modem wireless router has not obtained an IP address from 
your ISP.
If your router is unable to obtain an IP address from the ISP, the problem may be one of the 
following:
Your ISP may require a Multiplexing Method or Virtual Path Identifier/Virtual Channel 
Identifier parameter.
Verify with your ISP the Multiplexing Method and parameter value, and update the router’s 
ADSL Settings accordingly.