Netgear FVS318N Manual Do Utilizador

Enter the settings as explained in the following table: 

Do you want to 
enable DMZ Port?

Select one of the following radio buttons:

• Yes. Enables you to configure the DMZ port settings. Fill in the IP Address and 

Subnet Mask fields.

•  No. Allows you to disable the DMZ port after you have configured it.

IPv6 Address

Enter the IP address of the DMZ port. Make sure that the DMZ 
port IP address, LAN port IP address, and WAN port IP 
address are in different subnets. The default IP address for the 
DMZ port is 176::1. 

Prefix Length

Enter the IPv6 prefix length, for example, 10 or 64. The default 
prefix length for the DMZ port is 64.

DHCP Status

Specify the status of the DHCPv6 server:

• Disable DHCPv6 Server. This is the default setting, and the DHCPv6 fields are 

masked out.

• Enable the DHCPv6 Server. If you enable the server, you need to complete the 

DHCPv6 fields.

DHCP Mode

Select one of the DHCPv6 modes from the drop-down list:

• Stateless. The IPv6 clients generate their own IP address by 

using a combination of locally available information and 
router advertisements, but receive DNS server information 
from the DHCPv6 server. For stateless DHCPv6, you need to 
configure the RADVD and advertisement prefixes (see 

on page 93).

•  Stateful. The IPv6 clients obtain an interface IP address, 

configuration information such as DNS server information, 
and other parameters from the DHCPv6 server. The IP 
address is a dynamic address. (see 

on page 92).

Domain Name

Enter the domain name of the DHCP server.

Server Preference Enter the DHCP server preference value. The possible values 

are 0–255, with 255 as the default setting.

This is an optional setting that specifies the server’s preference 
value in a server advertise message. The client selects the 
server with the highest preference value as the preferred 
server.