D-Link AV 500 Manual Do Utilizador

•  Configure your Internet settings:

•   Go to Start > Settings > Control Panel. Double-click the Internet Options Icon. From the Security tab, click the button to restore the 

settings to their defaults.

•  Click the Connection tab and set the dial-up option to Never Dial a Connection. Click the LAN Settings button. Make sure nothing is 

checked. Click OK.

•   Go to the Advanced tab and click the Reset... button to restore these settings to their defaults. Click OK three times.

•   Close your web browser (if open) and open it.

•   Access the web management. Open your web browser and enter the IP address of your D-Link DHP-W310AV in the address bar. This should 

open the login page for your the web management.

•   If you still cannot access the configuration, unplug the power to the DHP-W310AV for 10 seconds and plug back in. Wait about 30 seconds 

and try accessing the configuration. If you have multiple computers, try connecting using a different computer.

If you forgot your password, you must reset your DHP-W310AV. Unfortunately this process will change all your settings back to the factory defaults.

To reset the DHP-W310AV, locate the reset button (hole) on the rear panel of the unit. With the DHP-W310AV powered on, use a paperclip to hold 

the button down for 5 seconds. Release the button and the DHP-W310AV will go through its reboot process. Wait about 30 seconds to access the 

DHP-W310AV. The default IP address is 192.168.0.50. When logging in, the username is Admin and leave the password box empty

This may due to the accidental change of the device password. Use the web-based configuration utility and select Setup > PLC SETTINGS. Fill in 

the password in the blank. Then repeat the same procedure to the other Powerline AV device via web-based configuration utility.

Please check your power supply is working. Powerline AV device operates from the power supplied by the home electrical wiring and can not 

operate without a working power supply.