Epson EL 486UC Manual Do Utilizador

The hard disk drive ribbon cable is attached to your system

board. You may need to remove it, for instance, to install a

cable that supports two hard disk drives in this system. See

“Connecting the drive cable to the system board,” below, for

instructions on reconnecting the cable to the system board.

Otherwise, see page 4-6 for instructions on connecting the

ribbon cable and power supply cable to the drive.

You should connect both the hard disk drive ribbon cable and

the power supply cable to the drive before you secure it with

the mounting bracket. You will not be able to attach them once

the bracket is in place.

If you need to connect the hard disk drive ribbon cable to the

system board, follow the steps below. (If the hard disk drive

ribbon cable is already attached to the system board, see

“Connecting the drive and power cables to the drive” on

page 4-6.)

1. Locate the hard disk drive ribbon cable; it is a flat cable with

a connector on each end and an additional connector on the

ribbon cable.

4-4 InstaIIing and Removing Drives