Yamaha Multitrack MD Recorder Manual Do Utilizador

Página de 115
Laser Diode Properties
* Material : GaAlAs
* Wavelength : 780–790 nm
* Emission Duration : Continuous
* Laser Output Power : Less than 44.6 
µ
W
Laser output is measured at a 
distance of 20cm from the object 
lens on the optical pick-up head.
(Note)
This unit is classified as a 
Class 1 laser product.
The CLASS 1 LASER 
PRODUCT label is located on 
the exterior.
CLASS 1 LASER PRODUCT
Klassmärkning för Finland.
CLASS 1 LASER PRODUCT
LUOKAN 1 LASERLAITE
KLASS 1 LASERAPPARAT
ADVARSEL
Usynlig laserstråling ved åbning. Undgå udsaettelse 
for stråling.
VAROITUS
Laitteen käyttäminen muulla kuin tässä käyttöohjeesa 
mainitulla tavalla saattaa altistaa käyttäjän 
turvallisuusluokan 1 ylittävälle näkymättömälle 
lasersäteilylle.
VARNING
Om apparaten används på annat sätt än i denna 
bruksanvisning specificerats, kan användaren utsättas 
för osynlig laserstrålning, som överskrider gränsen för 
laserklass 1.
CAUTION
USE OF CONTROLS OR ADJUSTMENTS OR 
PERFORMANCE OF PROCEDURES OTHER 
THAN THOSE SPECIFIED HEREIN MAY RESULT 
IN HAZARDOUS RADIATION EXPOSURE.
•This label is not placed on USA 
model and Canadian model.
•This label is placed on the lid.
•Varningsanvisning för 
laserstrålning. Placerad i 
apparaten.
CAUTION : INVISIBLE LASER RADIATION WHEN OPEN AND INTRLOCKS DEFEATED.
DO NOT STARE INTO BEAM OR VIEW DIRECTLY WITH OPTICAL INSTRUMENTS. 
VARNING : OSYNLIG LASERSTRÅLNING NÄR DENNA DEL ÄR ÖPPNAD OCH SPÄRRAR 
ÄR URKOPPLADE. STIRRA EJ IN I STRÅLEN OCH BETRAKTA EJ STRÅLEN MED 
OPISKA INSTRUMENT.
VARO!      : NÄKYMÄTÖNTÄ AVATTAESSA JA SUOJALUKITUS OHITETTAESSA OLET 
ALTTIINA LASERSÄTEILYLLE. ÄLÄ TUIJOTA SÄTEESEEN ÄLÄKÄ KATSO SITÄ 
OPTISEN LAITTEEN LÄPI. 
FCC INFORMATION (U.S.A.)
1.  IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions contained in this 
manual, meets FCC requirements. Modifications not expressly approved by 
Yamaha may void your authority, granted by the FCC, to use the product.
2. IMPORTANT: When connecting this product to accessories and/or another 
product use only high quality shielded cables. Cable/s supplied with this product 
MUST be used. Follow all installation instructions. Failure to follow instructions 
could void your FCC authorization to use this product in the USA.
3. NOTE: This product has been tested and found to comply with the requirements 
listed in FCC Regulations, Part 15 for Class “B” digital devices. Compliance 
with these requirements provides a reasonable level of assurance that your use of 
this product in a residential environment will not result in harmful interference 
with other electronic devices. This equipment generates/uses radio frequencies 
and, if not installed and used according to the instructions found in the users 
manual, may cause interference harmful to the operation of other electronic 
devices. Compliance with FCC regulations does not guarantee that interference 
will not occur in all installations. If this product is found to be the source of 
interference, which can be determined by turning the unit “OFF” and “ON”, 
please try to eliminate the problem by using one of the following measures:
Relocate either this product or the device that is being affected by the 
interference.
Utilize power outlets that are on different branch (circuit breaker or fuse) 
circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the antenna. If the 
antenna lead-in is 300 ohm ribbon lead, change the lead-in to coaxial type cable.
If these corrective measures do not produce satisfactory results, please contact 
the local retailer authorized to distribute this type of product. If you can not 
locate the appropriate retailer, please contact Yamaha Corporation of America, 
Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA 90620
IMPORTANT NOTICE FOR 
THE UNITED KINGDOM
Connecting the Plug and Cord
IMPORTANT: The wires in this mains lead are coloured in accordance 
with the following code:
          BLUE         :  NEUTRAL
          BROWN     :  LIVE
As the colours of the wires in the mains lead of this apparatus may not 
correspond with the coloured markings identifying the terminals in your 
plug proceed as follows:
The wire which is coloured BLUE must be connected to the terminal 
which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal 
which is marked with the letter L or coloured RED.
Making sure that neither core is connected to the earth terminal of the 
three pin plug.
IMPORTANT
Please record the serial number of this unit in the space below.
Serial No.:
The serial number is located on the bottom of the unit.
Retain this Owner's Manual in a safe place for future reference.