Infocus PRJ-WALLKIT-13 Manual Do Utilizador

PRJ-WALLKIT-13

Installation Instructions

InFocus and its affiliated corporations and subsidiaries 
(collectively "InFocus"), intend to make this manual accurate 
and complete. However, InFocus makes no claim that the 
information contained herein covers all details, conditions or 
variations, nor does it provide for every possible contingency in 
connection with the installation or use of this product. The 
information contained in this document is subject to change 
without notice or obligation of any kind. InFocus makes no 
representation of warranty, expressed or implied, regarding the 
information contained herein. InFocus assumes no 
responsibility for accuracy, completeness or sufficiency of the 
information contained in this document.

A WARNING alerts you to the possibility of 

serious injury or death if you do not follow the instructions.

A CAUTION alerts you to the possibility of 

damage or destruction of equipment if you do not follow the 
corresponding instructions.

Failure to read, thoroughly understand, and 

follow all instructions can result in serious personal injury, 
damage to equipment, or voiding of factory warranty!  It is the 
installer’s responsibility to make sure all components are 
properly assembled and installed using the instructions 
provided.

Failure to provide adequate structural strength 

for this component can result in serious personal injury or 
damage to equipment!  It is the installer’s responsibility to 
make sure the structure to which this component is attached 
can support five times the combined weight of all equipment.  
Reinforce the structure as required before installing the 
component. The wall to which the mount is being attached 
may have a maximum drywall thickness of 5/8" (1.6cm) for 
wood stud installation, and 1/2" (1.3cm) minimum for steel 
stud installation.

Exceeding the weight capacity can result in 

serious personal injury or damage to equipment!  It is the 
installer’s responsibility to make sure the weight of the 
projector does not exceed 25 lbs (11.3 kg).

Use this mounting system only for its intended 

use as described in these instructions. Do not use 
attachments not recommended by the manufacturer.

Never operate this mounting system if it is 

damaged. Return the mounting system to a service center for 
examination and repair.

Do not use this product outdoors.

The PRJ-WALLKIT-13 short throw projector 

mount is designed to be mounted to:

•

an 8" thick bare concrete wall;

•

an 8"x8"x16" bare concrete block wall;

•

a 2"x4" wood stud (16" on center) wall covered 
with drywall of 5/8" maximum thickness; or

•

a steel stud (16" on center) wall covered with 
drywall of 1/2" minimum thickness.