Chief Manufacturing EVCM-100D Manual Do Utilizador

 

Page 1 of 3 

8808-000006 RevA 

Prior to assembly, unpack carton completely and verify contents. 

If you are missing any of the following components, please contact Customer Service at 1-800/582-6480 

BEFORE PROCEEDING, READ INSTALLATION INSTRUCTIONS COMPLETELY 

WARNING!  IMPROPER INSATLLATION MAY RESULT IN SERIOUS 
PERSONAL INJURY! All components must be securely fastened to each other 
and to the ceiling. The overhead support must be capable of supporting five times 
the weight of the mount and equipment combined.  If it cannot is MUST be 
reinforced. 

Unit Specifications 
 

 

Run Time - 12 Minutes* 

 

Cool Time - 25 Minutes 

 

Run Time - 12 Minutes 

Do not exceed two cycles without an extended cooling period of 45 minutes.  To prevent 
damage to the Magna Lift, the unit will shut down for cooling if overheated. 

* It will take approximately 11 minutes to fully lower and raise 20 feet of cable under maximum load. 

Maximum Weight Capacity  .......................   250 lbs. (113.5) 
Maximum Travel  .......................................   20 feet (609.6 cm) 
Unit Weigh

t  ................................................   48 lbs. (21.6 kg) 

Electrical Requirements   ...........................   115 volts, 60 Hz, 1.6 amps continuous 

1.  Ensure 115-volt electrical power is readily available at the installation location. 
2.  Ensure support for the EVCM-100 ceiling mount is securely installed to the ceiling; if not 

the ceiling must be reinforced. Improper installation may result in serious personal 
injury. 

3.  Use the optional QD-1 for simplified installation or attach the EVCM-100 Magna-Lift 

directly to the NPT 1 1/2" column installed in your ceiling as follows: 

A  Thread the unit on the NPT 1 1/2" column and tighten securely using pipe 

wrench. 

B  After unit is tightened securely, install the thread locking set screw [Figure 1,  

Item (1) into the coupler, tightening it against threads on column.