Extron electronic PMK 560 Folheto

PMK 560 • Installation Guide

The Extron PMK 560 Pole Mount Kit, designed for use with the Extron PoleVault

™

 System, allows  

for easy mounting of PoleVault products to a projector pole. It is used to mount the PoleVault system switcher the associated 
power supply and an accessory device within an enclosure and below a suspended ceiling.

CAUTION: 

Maximum load for the PMK 560 is 15 lbs (6.8 kg)

.

Items included in the kit are:  
 

Covers (2), Base plate (1), Mounting plate (1), 

 

Tie wraps and pads (to secure power supply) 

 

4-40 Screws (to mount devices) (3),Cover Screws (4)

NOTE:  For full device installation, configuration, 

menus, connector wiring, and operation details of 
the PoleVault switcher, see the PoleVault System 
Installation Guide, available at 

Installation

To install the PMK 560 in a PoleVault system:

Remove the four cover screws from the center of the PMK 560  
(see figure 1). Slide the two halves apart and remove them from  
the base plate.

NOTE:  If the PoleVault switcher and its power supply 

are already installed, go directly to step 4.

To mount the PoleVault switcher, place the mounting plate, with 
the raised tabs upwards, on the top surface of the switcher and 
pass the two supplied 4-40 x 3/16 inch screws into the top of the 
switcher (see figure 2, 

b

). Secure the mounting plate but do not 

overtighten. 

Attach the associated power supply to the base plate with the 
supplied tie wraps and pads, by passing them through the 
appropriate slots and around the power supply (see figure 2 

c

). 

Tighten until snug.

Loosen the four pipe collar set screws (see figure 2 

d

), and slide 

the base plate up the pipe until it is touching the suspended ceiling.

Level the base plate and secure it by fully tightening the set screws.

NOTE:  At least three set screws must come in contact 

with the pipe.

Hook the combined plate and switcher into the PMK 560 base plate 
(see figure 2, 

e

). Secure it to the base plate with two screws.

ATTENTION: 

Use only supplied screws to avoid 

damaging the switcher.

Attach Mounting plate
to the top of the
PoleVault switcher.

Hook the combined mounting 
plate and switcher into the 
base plate and secure with 
screws.

Projector

Pole

Attach

Power 

Supply

Attach PMK to the projector 
pole pipe collar with the four 
10-32 set screws.

PVS 405D

Switcher

PMK Covers (2)

Base Plate

To open, remove 4 cover screws 
and slide the covers away.

Mounting Plate