Atlantis Land A01-AU3 Manual Do Utilizador
Clipper USB
1.15 Uninstalling the Clipper USB
Windows
The setup information for the Clipper is saved by Windows.
If you decide to permanently remove the driver and utility of
the Clipper from your system, you must run the
uninstallation program from the ISDN Utility program group
as follows:
If you decide to permanently remove the driver and utility of
the Clipper from your system, you must run the
uninstallation program from the ISDN Utility program group
as follows:
• Open the Programs folder on the Start menu and
click the Clipper ADSL USB Modem item.
• Click the Uninstall item. The uninstallation program
will run.
• A message will be displayed asking you to remove
of the ADSL USB Modem software, click Yes.
The USB cable should not be
unplugged until you are prompted to
do so.
The USB cable must be unplugged
before the system is rebooted.
unplugged until you are prompted to
do so.
The USB cable must be unplugged
before the system is rebooted.
Linux
To unload an unused module:
% rmmod ./GSPNModem (Command to be executed from
directory monaco_linux/ModemDrv)
You may need to exit or disconnect any program current
using the module before it will unload. If the module was
configured for LAN, shutdown the ethernet interface:
% ifconfig eth2 down
Note: If multiple ethernet interfaces are created then all the
ethernet interfaces need to be brought down before
% rmmod ./GSPNModem (Command to be executed from
directory monaco_linux/ModemDrv)
You may need to exit or disconnect any program current
using the module before it will unload. If the module was
configured for LAN, shutdown the ethernet interface:
% ifconfig eth2 down
Note: If multiple ethernet interfaces are created then all the
ethernet interfaces need to be brought down before