ArtDio IPS 1000 Manual Do Utilizador

                                                                       

      IPS 1000 Series VoIP Gateway

 

 

17

1.  Connect the IPS unit to a suitable Power source. 

2.  Connect a traditional phone set to the “FXS” connector located on the rear panel. 

3.  When the CPU/ACT light is on, pick up the phone to hear the dialing tone. 

4.  ##0000     

 

; you should hear three short tones. 

5. 011#   

 

 

; the digit “1” is used to enable “DHCP” IP mode. 

6. 15123# 

 

 

 

; “123” is the web management password. 

7. 981# 

   ; 

Warm-restarts. 

8.  Hang up the phone. The system should now restart. 

 

You can also use console to configure IP address. But phone number can’t be configured by 

console.(Only for 4 ports gateway) 

SIP-RG>enable 

SIP-RG#configure 

Enter configuration commands, one per line.    End with CNTL/Z 

SIP-RG(config)#ip state dhcp 

SIP-RG(config)#exit 

SIP-RG#restart 

This command resets the system.    System will restart operation code agent. 

Reset system, [Y]es or [N]o? Yes 

 

If your network environment is using PPPoE, you need to prepare the information as specified in section 

8. Information required before Installation. 

The following table shows an example. 

PPPoE Account 

83721@hinet.net 

PPPoE Password 

123ab 

Web management password 

123 

 

There are three ways to configure user name and password of PPPoE   

 

You can configure the user name and password by using phone set. The command ‘09’ is used for 

username and ‘10’ is for password of PPPoE. Since the user name and password use characters and