Manualsbrain.com
  1. Manuais
  2. Marcas
  3. Cisco Systems
  4. PLSK400
  5. Manual Do Utilizador

Cisco Systems PLSK400 Manual Do Utilizador

Download
Página de 120
8
Getting Started
PLEK400/PLSK400 Powerline Network Adapter
Troubleshooting
None of the LEDs turn on after you installed the Powerline adapter.
Follow these instructions:
1.  Disconnect the adapter from the power outlet 
2.  Disconnect the Ethernet network cable from the adapter  
3.  Wait five seconds 
4.  Re-connect the Ethernet network cable to the adapter 
5.  Re-connect the adapter to the power outlet 
6.  If  this  solution  does  not  work,  make  sure  that  the  electrical  outlet  is 
working properly  Plug a different device into the outlet, and try to turn 
it on 
The Ethernet LED does not light up on the Powerline adapter.
When the Ethernet port detects a local network connection, the Ethernet LED 
should turn on  Follow these instructions:
1.  Make sure that the Ethernet network cable is securely connected to the 
adapter 
2.  Make sure that the Ethernet network cable is securely connected to the 
computer or other network device 
3.  Make  sure  that  the  Ethernet  adapter  on  your  computer  is  working 
properly  Refer to Windows Help for more information 
You  cannot  connect  to  other  computers  on  your  local  network  or  to  the 
Internet.
If you did not set up advanced security for the Powerline network, follow these 
instructions:
1.  Locate the Powerline adapter connected to the computer that cannot 
connect 
2.  On  the  right  side  of  the  adapter,  use  a  pointed  object  to  press  and 
hold the Standby/Reset button for at least ten seconds  This resets the 
adapter to its factory default settings 
If  you  have  set  up  advanced  security  for  the  Powerline  network,  check  the 
following:
 
•
Make sure all adapters on the Powerline network have been configured 
with  the  same  network  password   The  network  password  must  be 
identical in order for them to communicate with each other  See “Setting 
 
•
If  you  are  adding  a  new  adapter  to  a  pre-existing  Powerline  network 
with a unique network password, follow the instructions in “Advanced 
The LEDs are flashing and I don’t know what it means.
Refer to the following table of LED behavior to help diagnose the problem:
Powerline LED
Off
Not connected to Powerline network
Flashing fast
Send/Receive data
Flashing slow
Pairing
Solid
Connected to Powerline network
Ethernet LED
Off
Not connected to Ethernet network
Flashing
Send/Receive data
Solid
Connected to Ethernet network
Power LED
Off
Device power off
Solid
Device power on and ready
Flashing fast 
momentarily
Factory default, Device wakeup from 
standby mode
Flashing fast 
indefinitely
Pairing error/system error
Flashing slow
Device in standby mode
WEB
If your questions are not addressed here, go to the Linksys Support