Cisco Systems 57712 Manual Do Utilizador
Purpose
Command or Action
For an alert to be sent, the filter trap settings must
be configured properly and platform event alerts
must be enabled.
be configured properly and platform event alerts
must be enabled.
Note
Commits the transaction to the system configuration.
Server /fault/pef # commit
Step 5
This example configures the platform event alert for an event:
Server#
scope fault
Server /fault #
scope pef 11
Server /fault/pef #
set action reboot
Server /fault/pef *#
set send-alert yes
Server /fault/pef *#
commit
Server /fault/pef #
show
Platform Event Filter Event
Action
Send Alert
--------------------- --------------------------- ----------- ------------------
11
11
Memory Assert Filter
reboot
yes
Server /fault/pef #
What to Do Next
If you configure any PEFs to send an alert, enable platform event alerts.
Configuring Platform Event Trap Settings
Before You Begin
You must log in with admin privileges to perform this task.
Procedure
Purpose
Command or Action
Enters the fault command mode.
Server# scope fault
Step 1
Enters the platform event filter destinations
command mode.
command mode.
Server /fault # scope pef-destinations
Step 2
Enables the platform event trap destination.
Server /fault /pef-destinations # set
enabled yes
enabled yes
Step 3
Specifies the destination IP address to which
platform event trap information is sent.
platform event trap information is sent.
Server /fault /pef-destinations # set addr
IP Address
IP Address
Step 4
Commits the transaction to the system
configuration.
configuration.
Server /fault /pef-destinations # commit
Step 5
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
152
OL-28893-01
Configuring Platform Event Filters
Configuring Platform Event Trap Settings