Cisco Systems 612 Manual Do Utilizador

To connect power to the device, follow these steps:

Review the information in the 

.

Plug the AC power cord into the power cord receptacle at the rear of the device. 
(See 

Connect the other end of the power cord to a power source at your installation site. 

Power up all externally connected devices.

Press the power control button on the front of the device.

The system should begin booting. Once the operating system boots, you are ready 
to initialize the basic software configuration. (See the 

 for a list of software configuration documents.)

While the device is powering up, the power LED on the front of the 
chassis is green.

When the device is up and running, observe the front panel LEDs. To verify that 
your system is operating properly, see the 

Before working on a chassis or working near power supplies, unplug the power 
cord on AC units. Statement 246