Canon AXIS 1650 Manual Do Utilizador

44

AXIS 1650 User’s Manual

Click on the Axis logotype to reach Axis’ home page.

A click on the question mark will open the print server’s help pages.

The following services are available from the Admin mode.

This page contains a section that allows you to view and modify the 

general parameter settings of the AXIS 1650. Management operations, 

like restarting the AXIS 1650 and resetting its parameters to their default 

settings are also available. 

Print Server Name

This name identifies the print server to the users. The default name is 

AXISXXXXXX, where XXXXXX are the last six digits of the print 

server’s serial number. 

System Location

This parameter shows where the print server is located, helping you to 

find the Canon device you are working with. 

Serial Number

Every Axis device is uniquely identified by its serial number. The serial 

number is found on the underside label of your print server. See “Print 

General Settings

In this section, you manage the print server’s general settings as well as 
permissions.

To change the print server’s general parameters, select Admin | General 
Settings => Change. For additional information, see “Setting General 
Parameters” on page 47.

To change print server permissions and restrictions, select Admin | 
General Settings => Change and select the Restrictions tab. For additional 
information, see “Setting Restrictions” on page 48.

Parameter List

Click Detailed View to see all parameters and their current settings. 

Restart

Restarts the print server. When the power LED lights constantly and the 

Network indicator starts flashing to indicate network activity, the print 

server is ready for use again. New configuration settings will then become 

active. All contact with the printer server will be lost during a restart.

Software Default

A Software Default will reset all print server parameters to their factory 

default settings except: 

•

Node address (NODE_ADDR.) 

•

IP address (IP_ADDR.) 

•

DHCP enabled or disabled (DHCP_ENABLE.)

A Software Default differs from a Factory Default. A Factory Default is 

performed by pressing the Test button, located on the print server, in a 

specific sequence. See “The Test Button” on page 61.

When the power LED lights constantly and the Network indicator starts 

flashing to indicate network activity, the print server is ready for use 

again.