Cabletron Systems W85 Manual Do Utilizador

Secure the HSIM-W85 to the module standoffs using the standoff 
screws included in the HSIM-W85 shipping materials.

Reinstall the interface module in the chassis.

Reattach the network cabling to the interface module.

To install an HSIM-W85 into a standalone device (e.g., 2H252-25R) 
perform the following steps:

Power down the device and remove the power cord.

Note the ports that have cables attached to them. Write down the ports 
and label the cables to make it easier to reattach the network properly 
after the installation. Then disconnect those cables from the ports.

Attach the antistatic wrist strap (refer to the instructions outlined on 
the antistatic wrist strap package).

Remove the standalone device chassis cover (refer to your specific 
standalone device documentation for instructions on removing the 
chassis cover).

 and remove the two faceplate mounting 

screws and the HSIM coverplate. Save the screws.

 and place the HSIM-W85 behind the 

standalone device faceplate.

Align the HSIM connector of the HSIM-W85 with the pins on the 
standalone device.

To install the HSIM-W85 in a standalone device, the device 
must first be powered down. Ensure that you remove the power 
cord and ONLY the screws required to remove the chassis 
cover.

Ensure that the HSIM-W85 connector aligns with the device 
connector pins to prevent bending the pins. This can damage 
both the HSIM-W85 and the device.