Avocent SPC420 Manual Do Utilizador

Página de 432
324        DSView 3 Software Installer/User Guide
Task: Configure SNMP trap settings on a managed appliance
This task turns SNMP traps on or off for one or more managed appliances of a particular type. To 
specify SNMP trap settings for other types of managed appliances, you must create additional 
tasks.
Once this task is added, you may run it on demand at any time; see Running tasks manually on 
page 334. Yo
u may also configure SNMP trap settings manually; see Managed Appliance SNMP 
Settings
 on page 149.
To add the task:
1.
Click the System tab.
2.
Click Tasks in the top navigation bar. The Tasks window will open.
3.
Click Add. The Add Task Wizard will appear.
4.
Select Configure SNMP trap settings on appliance from the drop-down menu. Type a 1-64 
character name for the task.
5.
Select a time to run the task (see Specifying when to run tasks on page 320), then click Next.
6.
The Select Unit Group window will open. Select All Appliances or select a unit group, then 
click Next.
7.
The Select Appliance Type window will open. Select the type of managed appliance for which 
to configure SNMP traps, then click Next.
8.
The Select Appliances window will open. Select one or more managed appliances from the 
Available Appliances list, then click Add. The unit(s) will be moved to the Appliances to 
Configure list. Then click Next.
9.
The Configure SNMP Traps window will open. Change the trap state by selecting one of the 
following from each trap menu, then click Next
No Change - uses the trap on/off state already configured.
Enable - turns the trap on.
Disable - turns the trap off.
-or-
Click one of the following buttons:
No Change All - uses the on/off states already configured.
Enable All - turns all traps on.
Disable All - turns all traps off.
10. Click Finish.
Task: Power control a target device
This task powers up, powers down or cycles the power (powers down and then powers up) of one 
or more target devices.