Sanyo POA-MD13NET2 Manual Do Utilizador
1
Selection of network menu
Turn on the projector and display the menu on the screen. Select network icon
from the main menu and then press SELECT button once. Check that the mode is
"On". If not, change mode to "On" using the point buttons (7 8).
from the main menu and then press SELECT button once. Check that the mode is
"On". If not, change mode to "On" using the point buttons (7 8).
16
Chapter 2 Installation
Network configuration (Type1)
Confirmation of the network menu
When installing this product to the projector, the network on-screen menu items for
this product are activated automatically. If not activated, the product may not have
been installed correctly. Please check item “Mounting” (
this product are activated automatically. If not activated, the product may not have
been installed correctly. Please check item “Mounting” (
☞ p.14).
Configure the network
When you connect the projector to the network, the network number of projector
must be the same as the network you intend to connect. You should configure pro-
jector’s network first.
This example explains how to set the following configuration.
must be the same as the network you intend to connect. You should configure pro-
jector’s network first.
This example explains how to set the following configuration.
The default network configuration is set as follows.
IP Address
: 192.168.1.201
Subnet Mask
: 255.255.255.0
Default Gateway : 192.168.1.1
DNS
DNS
: 0.0.0.0
IP Address
: 192.168.0.2
Subnet Mask
: 255.255.255.0
Default Gateway : 0.0.0.0
DNS
DNS
: 0.0.0.0
* The above on-screen display may differ from
the actual display depending on the functions
of the projector you use.
of the projector you use.
Network icon
Select "On" or "Off"
with 7,8 button
with 7,8 button
For the Projector which provides the Network main menu