Toshiba RKP004Z Manual Do Utilizador
2. Installing the LCD remote keypad
2-2
2.2 Installing the remote keypad to the board (optional)
The remote keypad can be mounted on a board by means of an IP54 attachment
(optional).
If an IP65 attachment (optional) is used in combination with an IP54 attachment, the
remote keypad can be installed where it may be splashed with water.
(optional).
If an IP65 attachment (optional) is used in combination with an IP54 attachment, the
remote keypad can be installed where it may be splashed with water.
Warning
Prohibited
● Never connect the unit to any inverter other than a VF-AS1/PS1 series
inverter or any communication device. Do not use any cable other than
an optional interconnect cable designed specifically for the unit.
If the correct cable was not used, this might cause the unit to break down
and result in an electric shook or fire.
an optional interconnect cable designed specifically for the unit.
If the correct cable was not used, this might cause the unit to break down
and result in an electric shook or fire.
Turn off the inverter, as shown in the figure below.
115
104
5.5
5.5
4-Ф3.5
100
114.
5
5
Make a hole in the board, as shown in
the figure below.
the figure below.
IP54 attachment
(optional)
(optional)
Dedicated interconnect cable
(optional)
(optional)
*
* The pin configuration of the dedicated
interconnect cable is different from that of
any other commercially available cable.
Therefore, be sure to use the dedicated
interconnect cable.
any other commercially available cable.
Therefore, be sure to use the dedicated
interconnect cable.
Tapping screws (4 pieces)
Used to secure the attachment.
Used to secure the attachment.
Remote keypad
IP65 attachment (optional)
Used to be attached to the IP54 attachment
Used to be attached to the IP54 attachment
*
Leave a space of 45mm or more
for the interconnect cable.