PioneerPOS G24-LC Manual Do Utilizador

This command handles the selection of the guard time, which is stored in S-Register 12, and 
specifies the behavior of escape characters during CSD connection.

For a guard time specified by S-Register 12, no character should be entered before or after 
"+++". The duration between escape codes must be smaller than the guard time.

The following table shows the S12 parameters.

This command displays the status of selected commands and S-registers.

This command sets the use of the software control. It is used for backward compatibility.

This command adjusts the terminal auto rate. It is used for backward compatibility.

This command displays the link type. It is used for backward compatibility.

This command has no effect, and only returns OK. It is used for backward compatibility.

The Set command sets the CSD escape 
character guard time value if all 
parameters are valid.

The Read command displays the 
current CSD escape character guard 
time.

CSD escape character guard time (units of 50 msec).
Range is 0 to 255. The default value is 20.