PioneerPOS G24-LC Manual Do Utilizador

The basic system configuration contains a modem and a terminal.

The G24-L is the modem and may be referred to as the DCE, the phone, the mobile or the radio.

The terminal may be referred to as the DTE or the TE.

The figure below shows a general messaging sequence of AT commands protocol between the 
terminal and the G24-L.

The AT commands interface is basically a Modem Services Upon Request.

Communication (almost) always begins from the terminal side. This means that any service 
should be requested from the terminal. Thus a request is called a "command".

Each command must be answered by a "results code" from the G24-L. The results code reports 
the command status to the terminal.

Some commands may include several "Response" requests (between 0 to K) to send data back to 
the terminal.

Some commands may initiate a mode in which, when specified events are generated in the 
G24-L, "Indicator" messages are sent asynchronously. Indicators can be between 0 to L.

The G24-L can echo characters received from the terminal (commands) back to the terminal.

Command

Terminal

G24-L

N

M

Response

Results Code

Indications

N

=

0,1

,

...

,

K

M

=

0,1

,

...

,

L