Verizon 7500 Manual Do Utilizador

 

 

 

 
 

030-300536 Rev. A 

94 

     August 2007 

 

Uplink Settings for Ethernet WAN Uplink (Routed IP protocol) 

Tunneling 

Factory Default = Enable 
If Enabled, this option allows PPP traffic to be bridged to the WAN. This feature 
allows you to use a PPPoE shim on the host computer to connect to the Internet 
Service Provider, by bypassing the Router’s capability to do this. 

DHCP Client 

Selecting a option allows you to either Enable or Disable the DHCP Client. 
Click the top option labeled (enable DHCP Client) to allow the Router to obtain an IP 
address automatically from your service provider. 
Click the bottom option labeled (disable DHCP Client) to allow the Router to accept 
static IP address information. Then, manually enter the IP values into the fields. Obtain 
these values from Verizon. 

IP Address 

The IP network address that your Router is on. 

Subnet 

The IP subnet address that your Router is on. 

Gateway 

The Router’s IP gateway address. 

DNS Primary 

Provided by Verizon. 

DNS Secondary 

Provided by Verizon. 

Note: The values for the IP Address, Gateway, DNS Primary, and DNS Secondary are all “Override of the value 
obtained from the PPP connection,” They default to “0.0.0.0,” in which case the override is ignored. It is 
recommended that you do not change the values unless Verizon instructs you to do so.