Novatel GM-14915118 Manual Do Utilizador

1

GM-14915118

 Rev 4

December 2013

This guide provides the basic information needed to set up and use your new NovAtel

®

 MEMS Interface 

Card (MIC). For more detailed information on the installation and operation of your MIC, download the 

 from our web site at 

.

In addition to this Quick Start Guide, the following is provided with your MIC:

• 1 MIC to IMU interface cable
• 1 IMU mounting PCB (printed circuit board) 

(a PCB is not included with the OEM-IMU-STIM300)

• Screws and standoffs for mounting the MIC

The additional equipment listed below is required for a typical setup:

• An OEM615 receiver

• An IMU (see the IMU Type column in Table 1, CONNECTIMU Commands on page 9)
• A 10-30 VDC power supply

• A wiring harness to provide power to the P101 connector on the MIC (10-30 VDC).
• A wiring harness to connect the customers equipment to the P301 connector on the MIC.
• A quality, dual-frequency GNSS antenna such as the GPS-702-GG. See the NovAtel website 

(

www.novatel.com/products/gnss-antennas/

) for information on a variety of quality antennas 

available to meet your form factor and performance needs.

• An antenna cable 
• A Windows

®

 based computer 



The MIC supports all OEM6

®

 family receiver cards for communications. The OEM615 is the 

only OEM6 family receiver card that can be directly integrated and powered by the MIC.



If the MIC is installed in a standalone configuration, a separate power supply is required for 
the OEM6 family receiver. For information about the power supply requirements, refer to the 
Technical Specification appendix for the receiver card in the 

. This user manual is available from our website at 

.