Nortel Networks 703t Manual Do Utilizador

October 2006

Installing the server and connecting the peripheral devices

703t Server Hardware Installation

65

1 Plug the server’s AC power cord into the server’s rear panel.

2 Plug the other end into a wall receptacle or power bar.

1 Press the server power switch to start the server.

2 Observe the Power-On Self Test (POST) and initialization messages on 

the monitor.

3 Let the mini-setup sequence run until you are prompted to log in to the 

operating system. 

Note: The system may perform multiple reboots. This is normal.

4 Ensure that the operating system logon window appears on the monitor.

Note: If the logon window does not appear, refer to the CallPilot 
Maintenance and Diagnostics guide for your server for troubleshooting 
instructions.

5 Proceed with the CallPilot server and switch configuration guide for your 

switch to connect and configure the server and switch.

You must connect the power outlets that are used by the 
CallPilot server and its peripheral devices to the same 
single-point ground reference as the one used by the switching 
system connected to the CallPilot server. 

If this requirement is not met, power transients can cause 
personal injury, hardware failure, or both. For more information 
on single-point grounding requirements, refer to the Installation 
and Configuration Task List (555-7101-210).