Nortel Networks Option 11C Mini Manual Do Utilizador
Chapter 4 — Creating an equipment layout plan and a card slot assignment plan
Page 79 of 332
Option 11C Mini
Planning and Installation Guide
Note 1: Install the NT6D70 SILC card in the Main Chassis (Slots 1, 2,
or 3) if it is used as a clock controller.
or 3) if it is used as a clock controller.
Make sure to first allocate the cards that you must install
in the Main Chassis.
Fill the remaining card slots as required.
If you plan on using the preassigned numbering plan with consecutive
numbers, make sure you assign all line cards in consecutive card slots.
numbers, make sure you assign all line cards in consecutive card slots.
NT8D16 Digitone Receiver
NT8D15 E&M Trunk
NT7D16 Data Access
NT6D70 SILC (See Note 1)
NT6D71 UILC
NT5K02 XFALC
NT5K18 XFCOT
NT5K17 XDDI
NT5K19 XFEM
NT5K36 XDID/DOD
NT5K21 XMFC/MFE
NTAG26 XMFR
CAUTION
If you use NE-A25B cables instead of NTAK19AA and NTAK19BA
cables with the NTAK02 and NTAK03 cards, continue with caution.
NE-A25B cables are not wired out to station equipment or trunk
circuits. NE-A25B cables can only be wired out to SDI circuits.
cables with the NTAK02 and NTAK03 cards, continue with caution.
NE-A25B cables are not wired out to station equipment or trunk
circuits. NE-A25B cables can only be wired out to SDI circuits.
Table 18
Card slot assignment plan (Continued)
Card slot assignment plan (Continued)
Card
Card slot
Number of
cards
cards