Nortel Networks MSC8101 ADS Manual Do Utilizador
MOTOROLA
MSC8101ADS RevB User’s Manual
19
Installation Instructions
3 - Installation Instructions
The MSC8101ADS may be configured according to the required working environment as follows:
•
Host Controlled Operation through OnCE Port
•
Host Interface Operation through HDI16 Port
•
Stand-Alone Mode
3•1
OnCE Connection Scheme
In this configuration the MSC8101ADS is controlled by a host computer via the OnCE Port, which
is a subset of the JTAG port. This configuration allows for extensive debugging using on-host de-
bugger. The host is connected to the ADS by a Command Converter provided by a third party
(Macraigor Systems).
is a subset of the JTAG port. This configuration allows for extensive debugging using on-host de-
bugger. The host is connected to the ADS by a Command Converter provided by a third party
(Macraigor Systems).
FIGURE 3-1 Host System Debug Scheme A
3•2
Host I/F Operation
In this configuration the MSC8101ADS is using HDI16 I/F that provide 16-bit wide, full-duplex,
double-buffered, parallel port to connect directly to the data bus of a host processor. The HDI16
supports two classes of interfaces:
double-buffered, parallel port to connect directly to the data bus of a host processor. The HDI16
supports two classes of interfaces:
•
Host processor/Microcontroller (MCU) connection interface
•
DMA controller interface
A Host Device may be connected to the ADS via dedicated 36pin two rows header or via 128pin
DIN - connector P2.
DIN - connector P2.
5V Power Supply
14 Wire
Flat Cable
Host
Computer
Media I/F
Command
Converter
Converter
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
.
..