Nortel Networks V.34 Manual Do Utilizador
Using the V.34 Modem Adapter Module in a Passport ARN Router
303127-D Rev 00
1-3
Completing Software Configuration
Once you have successfully installed the V.34 Modem adapter module, complete
the following software configuration tasks using instructions found in your BayRS
documentation:
the following software configuration tasks using instructions found in your BayRS
documentation:
For the latest information, be sure to review the release notes and documentation
change notice for your version of BayRS software.
change notice for your version of BayRS software.
Interpreting LEDs
The V.34 modem adapter module has four LEDs, located to the right of the
connector (Figure 1-2).
connector (Figure 1-2).
Figure 1-2.
V.34 Modem Adapter Module LEDs
Configuration Task
Location of Instructions
Connect the ARN to the network.
One of the following:
•
•
Installing and Operating Passport ARN
Routers
Routers
•
Configuring Remote Access for AN and
Passport ARN Routers
Passport ARN Routers
Modify the ARN configuration file to add the
V.34 Modem adapter module and enable
default software services.
V.34 Modem adapter module and enable
default software services.
When using Bay Command Console
(BCC
(BCC
™
) commands on an ARN router, note
that the name for the V.34 Modem adapter
module is arnv34.
module is arnv34.
Any of the following:
•
•
Configuring and Managing Routers with
Site Manager
Site Manager
•
Using the Bay Command Console
(BCC)
(BCC)
Configure V.34 modem services.
Configuring Dial Services
Telco
V.34 Modem
TX
RX
Complies with FCC Rules Part 68 Reg. Number 4P8USA-30661-MD-E Ringer Equivalence 0.6B
RLSD
DTR
ARN0107A