Farallon Communications 412 Manual Do Utilizador

Autobaud automatically detects your computer’s serial por t current 
data rate, up to 115.2 Kbps (autobaud does not suppor t 230.4 
Kbps transmissions).

To set the baud rate to the maximum speed of 230.4 Kbps, first 
make sure your computer’s serial por t and your communications 
software suppor t 230.4 Kbps transmission speed. Then send the 
following command to the Netopia ISDN Modem: AT $B 230400. 
Change the setting of your application program to 230400 bps. If 
you are using a Macintosh computer, star t up the ISDN Setup 
application and set the baud rate to 230.4 Kbps. (For more 
information, 

If you are using the Windows configuration program, autobaud must 
be enabled to access the Netopia ISDN Modem configuration dialog 
box. If the baud rate is set to a specific rate (such as 230.4 Kbps), 
you will not be able to access the configuration dialog box. 

Before you set the ISDN modem to a specific baud rate, make sure 
the configuration dialog box parameters are set correctly. To return 
to autobaud mode, set the baud rate of your communications 
program to the baud rate you defined for the ISDN modem and then 
send the following AT command: AT$B0. This sets the ISDN modem 
to autobaud. If you are still unable to access the configuration 
dialog box, press and hold down the “a” key on the keyboard and 
press the RESET key on the back of the ISDN modem. Hold the “a” 
key down until the ISDN modem comes back on line and then 
release the key.