Gateway E-9525R Manual Do Utilizador
Installing and removing drives
www.gateway.com
35
11
Align the optical drive with the two clips on the left side of the optical drive
tray, then press the optical drive into place in the tray.
tray, then press the optical drive into place in the tray.
12
Insert the optical drive tray into the bay in the media cage until it clicks
into place.
into place.
13
Insert the media cage into the assembly bay in the chassis.
14
Secure the assembly by tightening the thumbscrew you previously
loosened.
loosened.
15
Attach the 44-pin optical drive cable to the back of the optical drive
interface board.
interface board.
16
Reinstall the large fan cage by following the instructions in
17
Follow the instructions in
18
Reinstall the bezel, if required, by snapping it into place on the front of
the chassis.
the chassis.
19
Reconnect all power cords and peripheral device cables, then turn on the
server.
server.
Removing and installing a tape drive
To remove and install a tape drive:
Caution
The tape drive is not hot-swappable.
Before installing or removing the drive,
make sure that power is turned off and
the power cord(s) is unplugged.
1
Follow the instructions in
. Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
3
Follow the instructions in
.
4
Remove the large fan cage by following the instructions in
5
Disconnect the data and power cables from the tape drive.
6
Loosen the thumbscrew (1) holding the media cage in the chassis, then
push the assembly (2) out the front of the chassis.
push the assembly (2) out the front of the chassis.