Gateway E-9525R Manual Do Utilizador
CHAPTER 4: Installing Components
www.gateway.com
38
6
Make sure that the tray’s release lever is open, then slide the new drive
fully into the empty hot-swap drive bay.
fully into the empty hot-swap drive bay.
7
Push the lever back into place, then turn the lock clockwise to secure the
hard drive in the bay.
hard drive in the bay.
8
Reinstall the bezel, if required, by snapping it into place on the front of
the chassis.
the chassis.
Removing and installing a diskette drive
To remove and install a diskette drive:
Caution
The diskette drive is not hot-swappable.
Before installing or removing the drive,
make sure that power is turned off and
the power cord is unplugged.
1
Follow the instructions in
. Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
3
Follow the instructions in
.
4
Disconnect the USB cable from the diskette drive.
5
Lift the blue locking tab on the back of the diskette drive tray, then push
the drive tray out the front of the media cage.
the drive tray out the front of the media cage.
Blue locking tab