Fujitsu C120-E276-11ENZ0(A) Manual Do Utilizador

# ndd -set /dev/fjgi0 adv_1000fdx_cap 0

# ndd -set /dev/fjgi0 adv_1000hdx_cap 0

# ndd -set /dev/fjgi0 adv_autoneg_cap 0

# ndd -set /dev/fjgi0 adv_autoneg_cap 1

(Note) The last two commands above change the Auto-Negotiation setting, then change the

setting back. This causes the Link Status to change, and is required to make the settings

effective.

When the setting change is reflected in hardware (an Auto-Negotiation value being subject to change):

ndd -set /dev/fjgi* param1 value (Change of setting 1)

ndd -set /dev/fjgi* param2 value (Change of setting 2)

: :

ndd -set /dev/fjgi* adv_autoneg_cap N (Let Auto-Negotiation have a different value from the

current value.)

(Note) Please put a decimal number (instance number) in place of the asterisk (*).

example: When changing fjgi0 into 100Full (autonego=0, link_sppd=100, link_mode=1) from a default state (autonego=1,
link_speed=1000, link_mode=1) while Auto-Negotiation had been disabled.

# ndd -set /dev/fjgi adv_1000fdx_cap 0

# ndd -set /dev/fjgi adv_1000hdx_cap 0

# ndd -set /dev/fjgi adv_autoneg_cap 0

(Note) The last command above changes the Auto-Negotiation setting. This causes the Link

Status to change, and is required to make the settings effective.

- The ndd(1M) Command Parameters

The following parameters can be used with the ndd(1M) command.

Parameters:

Parameter

Status

Meaning

Read only

Display parameter list

link_status

Read only

0: Link down
1: Link up

link_speed

Read only

10: 10Mbps
100: 100Mbps
1000: 1000Mbps

link_mode

Read only

0: Half Duplex
1: Full Duplex

autonego

Read only

0: Auto-Negotiation is Off.
1: Auto-Negotiation is On.

flow_control

Read only

0: None (flow_control disabled)
1: LocSend (Can transmit pause frame only)
2: Rem (Can receive pause frame only)
3: Sym (Can receive and transmit pause frame)

cardtype

Read only

0: SX (SE0X7GD2X)
1: T (SE0X7GD1X/SE0X7GQ1X/SE0X7GQ2X)

- 29 -