Linksys WAP54GPE Manual Do Utilizador
15
Chapter 5: Setting Up the Wireless-G Exterior Access Point
Navigating the Utility
Navigating the Utility
Wireless-G Exterior Access Point
(192.168.1.245). Or if there is DHCP server connected to the switch, configure it to assign the IP address in
192.168.1.0/24 subnet. Your PC will get an IP address in the subnet through the DHCP.
192.168.1.0/24 subnet. Your PC will get an IP address in the subnet through the DHCP.
3. It is not recommended to use it this way, but you can connect your PC wirelessly to the Access Point when the
DHCP server is connected on the LAN side. It is not recommended because you can easily lose your
connection through configuration changes.
connection through configuration changes.
Launch your web browser, such as Internet Explorer or Mozilla Firefox and enter the Access Point’s default IP
address, 192.168.1.245, in the Address field. Press the Enter key.
address, 192.168.1.245, in the Address field. Press the Enter key.
Enter admin in the User Name field. The first time you open the Web-based Utility, use the default password,
admin. (You can set a new password from the Administration - Management tab.) Then click the OK button.
admin. (You can set a new password from the Administration - Management tab.) Then click the OK button.
After setting up the Access Point to use DHCP or manually configure a new IP address, move your Access Point to
the desired network. You will have to use the new IP address the next time you access the Web-based Utility.
the desired network. You will have to use the new IP address the next time you access the Web-based Utility.
Navigating the Utility
The Web-based Utility consists of the following five main tabs: Setup, Wireless, AP Mode, Administration, and
Status. Additional screens (sub tabs) will be available from most of the main tabs.
Status. Additional screens (sub tabs) will be available from most of the main tabs.
The following briefly describes the main & sub tabs of the Utility.
Setup
Enter the Host Name and IP Address settings on this screen.
Wireless
You will use the Wireless tabs to enter a variety of wireless settings for the Access Point.
•
Basic Wireless Settings. Choose the wireless network mode (e.g. wireless-G), Virtual Local Area Network
(VLAN) settings, SSIDs, and transmit rates on this screen.
(VLAN) settings, SSIDs, and transmit rates on this screen.
•
Wireless Security. Use this screen to configure the Access Point’s security settings.
•
Wireless Network Access. Use this screen to populate your Access List to permit or block certain MAC
address access to your wireless network.
address access to your wireless network.
•
Advanced Wireless Settings. Use this screen to configure the Access Point’s more advanced wireless settings
(e.g. Wireless Isolation, Output Power, etc.).
(e.g. Wireless Isolation, Output Power, etc.).