Dialogic TX4000 PCI SS7 Manual Do Utilizador

Complete the following steps to verify that each board is successfully installed: 

1 

Display a list of all of the TX boards detected in the system by entering the following command: 

txcpcfg 

txcpcfg displays the bus number, slot number, CP number, and CP model type of each detected 
TX board. For example: 

Bus    Slot    CP Number    CP Model 
5      7       1            TX 4000 
5      8       2            TX 4000 

If the CP number is listed as undefined, assign a CP number. For more information, refer to 
Assigning a CP number on page 22. 

2 

Ensure that each installed and configured board in the system appears in the list of boards.  

3 

Display a list by CP number and board type of all the TX boards in the system by entering the 
following command at the prompt: 

cpmodel 

cpmodel displays each TX board by model type and assigned CP number. For example: 

Board #1 is a TX 4000 
Board #2 is a TX 4000 

4 

Ensure that the boards listed by the txcpcfg utility in Step 1 are the same boards listed by the 
cpmodel utility in step 3. 

5 

Perform board-level diagnostic tests on each new board to verify the installation by entering the 
following command at the prompt: 

txdiag   -b   boardnum 

where boardnum is the CP number of the board. 

txdiag indicates the successful installation of the CP 1 board. 

TXDIAG V2.0: (c)Copyright 1998-2009 Dialogic Corporation.  All Rights Reserved. 
CP 1: NMI - Resetting... 
CP 1: NMI - ...Reset Complete 
CP 1: NMI - Starting test... 
CP 1: NMI - SUCCESS CP 1: MEMSWEEP - Resetting... 
CP 1: MEMSWEEP - ...Reset Complete 
CP 1: MEMSWEEP - Starting test... 
CP 1: MEMSWEEP - SUCCESSCP 1: INTR - Resetting... 
CP 1: INTR - ...Reset Complete 
CP 1: INTR - Starting test... 
CP 1: TXDIAG - Resetting... 
CP 1: TXDIAG - ...Reset Complete 

 

Refer to the Dialogic® TX Series SS7 Boards TX Utilities Manual for detailed 
information about txcpcfg, cpmodel, and txdiag.